1. In this scenario, an illegal operation occurred during the check run process.
2. Re-start NDS.
3. When the menu is open, press the [Restart Job] button.
4. Enter APCP in the first field.
5. Use the List of Values to select the correct sequence where the illegal operation occurred.
* 1 apcp1 Check Printing: Runs the first form where the batch number, last check number, and process checks flag are entered.
* 2 apcp9 Check Run: This is the message inquiring whether you want to print checks.
* 10 apcc3 Check alignment preparation: This is the message inquiring whether you are ready to print alignment checks.
* 11 chktest AP CHECK ALIGNMENT: Prints the alignment checks.
* 12 apcc4 Check Alignment Post Process: Prints the alignment checks.
* 15 apcp9 Press OK if aligned. Canc to Reprint: Message inquiring whether checks were aligned or if the alignment checks need to be reprinted.
* 19 apcc2 Assign Check Nos and Print Checks: Message inquiring whether you are ready to assign the check numbers and print the checks.
* 20 apcc1 Check Print Preparation: Assigns check numbers and prepares to print checks.
* 21 checks AP CHECK PRINTING: Prints the checks.
* 23 apcp2 Check Print Statuses Update: This is the second form where the check run results are entered. If checks have been printed, select this sequence.
* 25 apcp6 AP RESET CHECK TABLE: Resets check table
* 30 apcp8 AP RESET Batch TABLE: Resets batch table.
6. Press the [Restart Job Stream] button.